Thanks for It is located under the backlight connector, PR21
Sometimes black spots appear in different places, the brightness of the backlight sometimes drops sharply on LG TVs, etc.
Highlight link HERE This is how the backlight changes in this TV model. But more often just a black screen. As usual. Someone already repaired a year ago, judging by the inscription. But additionally there are latches. We snap off the latches around the perimeter, do not forget to peel off the matrix board from the TV case.
More board
During installation, I noticed that the polarity does not match, but this is a “marriage” that does not affect operation.
The bars are screwed to the TV case – unscrew and change to new ones In this topic I will tell you and show you how to replace the backlight on your Philips 32PHS4062/60 TV yourself. I prefer to shoot together in a frame.
Unscrew the screws around the perimeter that hold the frame.
Remove the diffusing films When installing the matrix, we make sure that all the corners are in their places, do not lie on the plastic frame. The current was underestimated – this is good, but this did not save from breakdown.

Replacing the backlight on a Philips 32PHS4062/60 TV

Hello everyone!

We transfer it to a free space (I do this by holding the frame from top to bottom in the middle) We start disassembly by removing the back cover. Attention! If you do not have experience in parsing TV or other similar equipment, it is better to give it to the masters! Otherwise, there is a risk of damaging the matrix. Change the backlight completely, do not save! Now you need to remove the matrix. We put the screen down on a flat surface and unscrew all the screws. TV made in mid-2018 (worked ~ 3 years).
I changed the backlight in September last year, the photo did not survive, but no flashes or other things were observed. Otherwise, in case of damage, you will have to go to the store for a new TV We assemble everything in the reverse order. Careful with cables to the matrix! How can I tell if the backlight is the problem? Usually this is – there is a sound, but there is no image (it is viewed if you shine a flashlight on the screen). Disconnect all wires, remove all boards and speakers
Remove the cover. Now you need to lower the current – this was done before me, showing the resistor that needs to be removed.
Turn the TV over (holding the matrix with your fingers on both sides) and snap off the frame with a plastic card. Or be very careful! https://jiji.ng/auchi/land-and-plots-for-sale I am not responsible for your actions.